Process:
- Elecrit Microphone Amplifier (Sound Sensor) Part and Wiring:
Not included in our toolkits, but manageable to find. Three pins must be soldered into OUT, GND, and VCC.
Wiring done before the part had been soldered.
Diagram of wiring from initial part documentation.
Elecrit Microphone Amplifier (Sound Sensor) added to wiring. The sensor needed to be manually adjusted using a small screw on the bottom of the device to arrange for tolerances and sensitivity.
- LED Part and Wiring:
Standard LED found in toolkits.
Wiring for LED alongside sensor wiring.
- Piezo Part and Wiring:
Part included in our kits. Outputs sound that can be modified with frequency adjustments.
Fritzing diagram for Piezo wiring:
- Final finished breadboard:
Content Rating
Is this a good/useful/informative piece of content to include in the project? Have your say!
You must login before you can post a comment. .