Back to Parent

Process

I started the project by implementing a temperature sensor which would be used to monitor the room. later I started thinking of ideas the way it would be connected to the heater. I later installed LEDs to indicate the heater's temperature is being increased and used a servo to open the windows. So the Servo would open the windows, and then TMP36 would read the data, if it's getting very cold, the heater would be adjusted and this is when one led glows, if still the temperature is cold, the heater would again be adjusted which is shown by the blinking of second led. 


Content Rating

Is this a good/useful/informative piece of content to include in the project? Have your say!

0